Study guides

Q: How do you check mega ohms on compressor?

Write your answer...

Submit

Related questions

One mega-ohm is the equivalent of 1000000 ohms.

M is a si siffix for mega. It means million. 20 mega-ohms is 20 million ohms.

Yes, and in kilo ohms and mega ohms

It is 0.00000002 megaohms.

Mega is 8 X 10^6 and Kilo is 8000 X 10^3. For every 3 you go down in powers you divide by 1000, so 8 Mega ohms is 8,000,000 ohms. 8,000 Kilo ohms or 0.008 Giga ohms.

S = 1/R Where S = Conductance in Siemens R = Resistance in Ohms If R is in Mega Ohms, S will be in Micro Siemens

1 million ohms 1,000,000 ohms

Ten mega ohm equals 10,000,000 ohms.

Yes, one mega ohm is more than one kilo ohm. Mega means million, kilo means thousand.

A Megohm is one million ohms. To convert ohms to Megohms, divide by one million.

It is a stronger isolator, meaning that it leaves less current through.

you can't, different units

1000 kilo (Thousand) Ohms is one mega Ohm or 1,000,000 ohms

use a merger tester, if there are no indication to certain number of ohmic (50 M), that is mean resistor is open.

A mega ohm is 1 million Ohms and is variously shown as 1M, 1MOhm and 1MR

First make sure power is off...there is three leads that supply power to compressor...they should be Yellow Black and Red....make a diagram where these leads connect on your unit and then disconnect them...You will need a multi meter to check ohms of resistance...Yellow is usually the common lead...attach one meter lead to it...now touch other meter lead to black lead...should read somewhere between 1 to 4 ohms...now touch the meter lead to the red wire...should read somewhere between 3 to 7 ohms...next read from yellow lead to side of compressor...if you get any reading then compressor is grounded and needs to be replaced...if you get no reading there, reconnect lead and see if compressor will run...if it will not then if could be possible capacitor is bad...on some units they have start assist capacitors this could be bad also..replace these and see if compressor runs...if it will not run it will need to be replaced..if it does run use an amp meter and check load amps of compressor...

Ohms and volts are different things -- it's not possible to equate ohms to volts.

differs person to person it lies in the rang of several mega ohms

The answer is .047Megohms. 1kilo ohm is 1,000 ohms. 1mega ohm is 1,000,000 ohms. Just move the decimal over to convert.

Mega means million, so that would be 106 ohms. You can also write this as 1 x 106 ohms.

1 megohm is 0.1 gigaohm. 1 gigaohm is 1000 megaohm. 1 megohm = 1,000,000 ohms = 106 ohms. 1 gigaohm = 1,000,000,000 ohms =109 ohms.

A capital 'M' followed by the Greek symbol omega.

Yes. It is of the order of 100 Mega Ohms.

5 mega ohms and above

1 megohm is 1 million Ohms